Don’t Know How to Change a Flat Tyre? Well, Now You Will!

The longevity of your car tyres depends on numerous factors including driving habit, road conditions, care and maintenance, etc. It also depends on the kind of tyres you’re using. So, if you’re using run-flat tyres in Manchester or anywhere else in the UK, you know you can drive to a garage as long as it’s within 50 miles of where you are.

But, if you have a regular tyre, a blowout or puncture will leave in you in a proper debacle, unless you know how to change the tyre.

What follows is a list of easy step-by-step guide to help you change a flat tyre!

Step 1: Find a level and safe place

Using your vehicle’s emergency brake and parking it on a level surface is the essential first-step of replacing tyres. It will ensure your car does not roll forward or backwards. Not doing so can make your job difficult and risky. Your vehicle may move or shift towards the slope after being dislodged from the jack.

Step 2: Steady the wheel

It means that you have to place something robust to secure that flat tyre and avoid any chances of rolling. You can make use of sturdy materials like bricks, tree limbs, rocks, etc. that come with few inches height for chocking.

Step 3: Loosening those lug nuts

Get your lug wrench to loosen the nuts. But don’t remove those nuts entirely yet.

Step 4: Raising your car with a jack

This will require you to refer the owner’s manual and know where you must place the jack. In general, you can consider putting the jack behind the wheel with the flat tyre. Now, raise that jack to the right length without over-tilting your car.

Step 5: Begin to crank up that jack

Lift your vehicle at least six inches above the surface with the help of your jack. Now you can remove that tyre securely. Keep everyone away from your vehicle, as it is not entirely stable.

Step 6: Removing the tyre, finally!

Unscrew those lug nuts and remove them. Now, gently pull out that flat tyre. Make sure to avoid damaging the rim or the wheel assembly while removing the flat tyre.

Step 7: Putting up your standby tyre

Line up those lug nuts along the holes. Smoothly slide up the spare tyre and tighten the lug nuts. Lower the car jack to move onto the next and the last step.

Step 8: Tightening the lug nuts

Use the lug wrench to tighten your wheel’s lug nuts entirely. Since the vehicle is safely on the ground now, use full force to fasten those nuts.

However, it is a better option to avail mobile tyre fitting services where you don’t have to wait for hours. You do not need to go through all the hassle of changing the tyre yourself.

Numerous auto shops in the UK come to your aid for problems concerning car tyres in Manchester, such as the Gilgal Tyre.

Drive on and have a safe journey!

Leave a Reply

Your email address will not be published. Required fields are marked *