Vinyl wrapping of the car

 

What is the Vinyl wrapping of the car

Most of us like to keep our vehicles always new and would like to beautify it with modernity. Wrapping is chosen to do so. More people consider taking vinyl car wrapping, and the same has been recommended to others. Vinyl wrapping makes your car more versatile than the traditional paints, and it shields your vehicle’s paintwork by glueing a vinyl coating layer at the top of an existing painting. Multiple colours of vinyl give a unique look to your car undoubtedly. You can do it by yourself. However, this intricate job needs a well-trained technician to perform the work impeccably. A comprehensive guide for vinyl wrapping is given here.

Planning

Before you order vinyl, plan your idea. Measure the wrapping area first. After arriving the length and width, multiply them to fetch the material amount required to do it. After figuring the wrapping area, add it. Finally, add another ten sq/ft to the number, and you will get the amount of vinyl film to be ordered. Always order a vinyl of high-quality. Good brands of vinyl will never spoil your paint. Though low-priced products may give a good look initially, after some time, the vinyl starts losing its colour. Before beginning to wrap, any inside liners, handles, trim and mouldings should be removed that might disturb the entire covering.

Cleaning

Using a degreaser for removing any dirt on the car helps in perfect vinyl wrapping. Then, the same area is cleaned with Isopropyl Alcohol. Now, the work area is clean. The entire area must be kept dust-free to ensure that none of the dirt is settled back on the vehicle. After cleaning the surface of the car, if any scratch, bump or chip is found, some bodywork should be performed to get a smooth surface.

Measure & Cut

Once the surface of the car is picture-perfect, as a skilled person, you may trim vinyl to a smaller size to save your money on it. But, beginners may feel comfortable working with more vinyl than less. The vinyl sheet is available in 60X25. When you watch, more vinyl panels on cars are smaller than sixty inches. If you are opting for vinyl wrap car Birmingham for the first time, better start with a small surface.

Applying vinyl wrap on the car

Check the surface of your vehicle twice and thrice for any dust or debris. Keep your hands clean and pull off the backside of vinyl sheet. Now, the adhesive is ready to stick on the car. Start from the middle, and gradually reach the outside corners. Using squeegee press the film on the vehicle with even pressure at the starting point. A slow start from the centre to ensure the application is smooth. Check out the air by handling a heat gun on the flat area. It will start to bubble if any air is found, and you can push it out if your vinyl sheet contains an air release feature.

Cut extras, tuck and heat

Now, it is time to trim the extra vinyl hanging in all edges by leaving ¼ cm for tucking around the corners. Once the cutting work is over, now it is to be tucked in all sides. In a proper wrap, you could not see wrinkles. If you find more stretch, the edges could not be adequately wrapped. Using heat gun and thermometers eases the stretches on sharp bends. Heating the vinyl sheet about ninety degrees will smoothen it so that wrinkles can be easily even. Doing overheating may degrade the quality of the vinyl sheet.

Once the vinyl wrap turns smooth using alcohol, clean the wrapped area and examine your work.

Leave a Reply

Your email address will not be published. Required fields are marked *